03/01/10 - New! Surge Guard 30 & 50 AMP Regulators

Don’t Worry About Low Park Power Again!

Today’s RV’s contain advanced electronics including computers, TV’s, satellite receivers, microwave ovens, air conditioners and other sophisticated appliances. Poor power quality entering an RV can not only effect the longevity of electronic equipment and motors, but can lead to thousands of dollars in repairs and create frustrating, unnecessary travel delays.

In addition, the Surge Guard Voltage Regulators are the first boosters that include intelligence with easy-to-read LED status and fault indication panels. These LED’s show ground status line conditions as well as indicate the under/over voltage conditions of each output line. This product is designed to be fault tolerant so that it can not be damaged by an open neutral that results in high voltage on one of the incoming lines.

In the Low Voltage (Boost) Mode the Surge Guard Voltage Regulator raises the output voltage by 10%over the incoming line voltage. In the Bypass (No Boost) Mode the unit becomes a bypass element and simply passes the input voltage directly to the output. In the bypass mode the unit exhibits minimal insertion loss.

Using the Surge Guard Voltage Regulator in conjunction with a Surge Guard® RV power protection product provides the ultimate combination of low voltage and Surge Guard protection. The Surge Guard must be plugged in after or down stream of the Surge Guard Voltage Regulator. A variety of Surge Guard products protect your RV from: High/LowVoltage, Open Neutral, Miswired Pedestals, and Surges

FEATURES

  • Boosts as low as 95Volts

  • 10%voltage increase

  • Provides a reliable source of power

  • Helps prevent low voltage damage to appliances

  • Easy-to-read LED Status and Fault Indication Panel

  • Fully automatic – Continuously monitors line voltage conditions

  • True bypass mode – input voltage is equal to output voltage

  • Increases voltage to an acceptable level

  • Rain-tight enclosure

  • Mounting feet so unit does not sit in water

  • Optional mounting bracket for inside the RV

Model 10175

Rated 120V/240V, 50A

For use on single phase, 3-wire service

  • Can be used on a 120/208V, 3-wire network

  • Weight: 42 lbs.

  • Dimensions: 10.25”L x 10.25”Wx 5”H

  • Cord Length: 4-5 Feet

  • Mounting Feet Height: 2.5”

  • (Optional) Mounting Plate Height: 0.75”

[Click Here for 50 amp Details]

Model 10176

Rated 120V, 30A

For use on single phase, 2-wire service

  • Weight: 21 lbs.

  • Dimensions: 10.25”L x 10.25”Wx 5”H

  • Cord Length: 4-5 Feet

  • Mounting Feet Height: 2.5”

  • (Optional) Mounting Plate Height: 0.75

[Click Here for 30 amp Details]

 




Page :  1